Tractor Talk Discussion Board |
Re: 2N Starter Can't get it out of there! STuck on Bell Thing!
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by JK MN on May 24, 1999 at 11:18:09 from (207.242.199.131):
In Reply to: 2N Starter Can't get it out of there! STuck on Bell Thing! posted by matt on May 24, 1999 at 02:18:26:
Matt, Since you have the starter in pieces, and all that is left is the armature with the dirve left on it, there should be plenty of room to get it out, unless it has the drive with the "big" barrel, since you are calling it a bell shape. The "small" or origional drive is parallel in shape and is approx 1 11/16" diameter, with a spring on the "far" end. You may end up splitting the tractor at the bell housing, (like doing a clutch job), as someone may have installed the drive from the inside. The correct way to install the "big" barrel drive is to grind out the starter "hole" in the bell housing. You may be able to get a Dremel type grinder and enlarge the hole, and that way you won't have to split the tractor. (The "big" barrel is approx 2" OD). Good luck.
Follow Ups:
Post a Followup
|