Tractor Talk Discussion Board |
Re: 9N just stall after running a bit.
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dell (WA) on June 22, 2005 at 00:09:57 from (172.192.84.68):
In Reply to: 9N just stall after running a bit. posted by San Diego Dude on June 21, 2005 at 08:06:01:
Dude........there are 4-common runtime issues with the squarecan frontmount 9N-Engine. 1) runs for about 1-min and quits, bad condenser NOT yer stated problem 2) runs for about 5-min and quits, clogged fuel filters (3 of them) NOT yer stated problem 3) runs for about 15-min and quits, gunked up ignition switch guttz NOT yer stated problem 4) runs for about 1-hr and quits; restarts after 2-hrs or overnite cool-off Sound like yer problem? BAD SQUARECAN IGNITION COIL Heres the deal, unfortunately the squarecan ignition coil is NOT as robust as we'd lik'em to be and engine heat, external heat, excessive ignition amps from by-passing the "infamous ballast resistor" will cause the insulative tar to melt and short out some of the coil winding and WEAK SPARKIES. When the coil has a chance to cool-off, the insulative tar hardens and now yer coil is making barely adequate sparkies. Do I haffta tell ya? REPLACE yer squarecan ignition coil. And DON'T BY-PASS yer "infamous ballast resistor" in a miss-guided shadetree mechanic's search for hotter sparkies and eazier starting 'cuz you'll just melt yer coil again. Remember the 6-volt MANTRA: "keep'em clean, bright, and tight".........respectfully, Dell, yer self-appointed 9N sparkie-meister
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|