Tractor Talk Discussion Board |
Re: Hey Zane - help with NAA Hyds
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dan on May 19, 2005 at 06:48:46 from (66.15.112.136):
In Reply to: Hey Zane - help with NAA Hyds posted by Mstrumpet on May 18, 2005 at 17:16:14:
I will preface this post by telling you I am pretty green and NAA hydraulics. I just rebuilt my entire system from pump to lift cover. One thing I kept finding in all my research was how prone these NAAs are to valve sticking. It sounds to me that is your problem. I too had this issue, even after a full rebuild (taking every valve out and cleaning it, new ring, etc.) What I finally did was put a quart of ATF in my hydraulic chamber and let it run lifting the arms, lowering, lifting, etc. The detergent in the ATF worked and unstuck the valve, now my lift lowers as it supposed to and works just great. Good luck, Dan
Follow Ups:
Home
| Forums
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|