Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Tractor Talk Discussion Board

Re: how hard to run a diesel engine?????


[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by Hugh MacKay on April 12, 2005 at 09:07:03 from (64.228.11.167):

In Reply to: how hard to run a diesel engine????? posted by vabill on April 12, 2005 at 06:40:28:

bill: Most important with the diesel is keep temperature in operating range suggested by manufacturer, usually around 180F. Do your work between max torque and full throttle. maximum torque on most diesels around 1,500 rpm.

Full throttle is a bit of a myth. Look at the big rigs on highway, most of them never run at full throttle. Most of them at 65 mph are turning 1,650 rpm in high gear. Cat will even tell you not to be afraid to lug their truck engines to 1,000 rpm, short term, if it avoids spinning out on an icy hill, from shifting gears.

Remember the efficiency of a diesel lies in that maximum torque at low rpm. You see guys buy a diesel pickup, put in 4.10 axle gears so it will make lots of noise and burn just as much fuel as a gasser. Plus it will turn 2,800 rpm on highway driving. I ran a 6,2 Chevy with 3.24 gears half million miles with no rebulild and got 30 miles to Canadian gallon (24 US) It turned 1,800 rpm on highway. And we all considered the 6.2 a Mickey Mouse affair.

After my many years experience with diesels I would never buy another diesel with a governed range higher than 2,000 rpm. Just look at the 475 hp Cat on highway, governed under 2,000 rpm, pulling 140,000 lbs, it will accelerate just as fast in either of the two closest gears, at about 40 mph. IH and Deere for example didn't need 2,400 rpm to get same hp out of those diesels they were using in the 70s. RPM's were just to wear then out faster. There was no choice standard pto was at 2,300 rpm, or there abouts.


Follow Ups:




Post a Followup

:
:
: :

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle? ... [Read Article]

Latest Ad: Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy