Tractor Talk Discussion Board |
Re: Need Help From A Restorer
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Harley on April 08, 2005 at 17:18:40 from (66.82.9.77):
In Reply to: Re: Need Help From A Restorer posted by Allan in NE on April 08, 2005 at 11:41:31:
If you would just get the thing home, get her lined up on the corner post at the other end of the field, take your right hand, place it on the throttle lever, release clutch slowly, pull throttle back till it stops, drive to other end of field. It's not rocket science old buddy. How many M's had tacks on them, and I bet you didn't worry about how fast the engine was running. As long as it is pulling what is behind it, it is running fast enough. Jeesh. :-) Harley
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|