Tractor Talk Discussion Board |
Re: Ford vs. Cub or A
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob on March 05, 2005 at 18:31:13 from (66.163.134.177):
In Reply to: Re: Ford vs. Cub or A posted by Bigdog on March 05, 2005 at 18:16:47:
Been there, done that, BG, and it always worked until one day I wasn't quick enough, and the bucket on the 8N's FEL was pushed through the polebarn wall before I could pop the tranny out of gear. If the ground is soft, or the powertrain is otherwise loaded, it can be difficult to slip the tranny out of gear. I went out and bought an ORC, and installed it before using the rotary cutter again. There's always that one time you're not quick enough, or perhaps someone else will hop on someday, with no experience, and have a wreck. There's no reason NOT to have an ORC. A guy can still be "macho" and have an ORC! (Lately, I have even begun to wear eye protection while mowing!)
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|