Tractor Talk Discussion Board |
Re: needle valve won't quit leaking
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Vern-MI on March 03, 2005 at 11:39:50 from (207.69.138.198):
In Reply to: needle valve won't quit leaking posted by cjm in wi on March 03, 2005 at 10:36:13:
Contaminant in the gas in the form of VERY small rust particles will prevent the needle from fully seating. You may want to try additional in-line pleated paper gas filter. Otherwise you may have to resort to turning off the gas valve when not using or find a suitable viton tipped needle to use in place of the metal one. This will allow some compliance and effect a seal between the needle tip and seat. I had to do this on an old motorcycle in order to get it to stop leaking. Ended up finding a viton tipped needle which fit the same diameter but was to long then grinding the overall length to match the original solid steel needle.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|