Tractor Talk Discussion Board |
Re: 3 pt Cultivators
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Upon further review..... on January 21, 2005 at 17:02:19 from (204.255.239.177):
In Reply to: Re: 3 pt Cultivators posted by BillKY on January 21, 2005 at 16:53:16:
Me again! (BillKY) After re-reading your original post, I think you might get away with a 5'er, provided you don't try to go too deep. With it set at around 4" to 5"s, you should be able to power that tiller. Just be patient, and don't try to knock it all out in a few minutes. If you run into a "lack of power problem" just don't run it so deep. Also, you can overlap your passes somewhat to lessen the load on your tractor. Again...GOOD LUCK!
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|