Tractor Talk Discussion Board |
Re: What is a 3 point hitch?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mike M on December 22, 2004 at 05:42:16 from (24.140.40.90):
In Reply to: Re: What is a 3 point hitch? posted by paul on December 21, 2004 at 20:08:43:
I'm going to agree with some of your nit picking. I don't know much about computers,but I doubt Windows was/is the best. Designed by geeks made for geeks not a simpleton like me. I curs those three points quite a bit when hooking up implements,gotta pull those arms out to the side to hook up then there not in line anymore to slide on.Those quick couplers are a good remedy but all demensions are not the same cat. 1 has alot of width variance. I have used the IHC fast hitch a little bit and liked it as long as you had the implements blocked to the right height.If I used it more I may have found some shortcomeings but it seemed pretty simple and effective.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|