Tractor Talk Discussion Board |
Re: Jerky Backhoe
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by T_Bone on December 09, 2004 at 18:52:55 from (4.240.42.142):
In Reply to: Jerky Backhoe posted by Russ(NC) on December 09, 2004 at 12:12:41:
Hi Russ, Sounds like water seperated out of the oil in the bucket cylinder during storage. If the cyl rod was in, then water would be all at the lower end. If the cyl rod was out then there could have been water on top of the bore piston. If it was water then the bore is ruff with rust, probably about 8" of the bore. I used a engine cylinder hone with lots of oil to remove rust. Could have split a piston seal the last time out. The oil is by-passing the piston seal. If there were other hydraulic problems up the line then all cylinders would act the same way. That tells me you dealing with just one bad cylinder. There easy to rebuild, give it a try. I have seperated water out of hydraulic oil by letting the oil sit for several months, then syphion off the oil at the top as the water will settle to the bottom of the can. I still can't find out where the water is getting into my system but about every 3yrs it gets about gallon of water in 20gal of oil. T_Bone
Follow Ups:
Home
| Forums
Today's Featured Article -
History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|