|
Tractor Talk Discussion Board |
ot:: (just can't get it) international loadstar
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by steve_ne on November 17, 2004 at 07:43:59 from (64.89.178.205):
Please help before I go mad.
New parts list.
Replaced pushrods....two broke
rebuilt starter
tested alternator
charged battery
new condensor
rotor arm
distributor cap
spark plugs
points
voltage regulator
condensor off of voltage regulator
ingnition coil
starter switch
replaced all fuses
replaced all lose connectors
rebuilt carborator(holly)
cleaned out gas tank(new gas)
cleaned intake maifold
replaced exhaust manifold
replaced oil in air filter
Truck: 1967 loadstar 1600 v8 345
Problem:
will start run until its shut off will start right backup. If you run it then shut it off and let it sit for more then a minute. It will not start. pulled plug and no spark. Wait 45 min. or more and it will start right up and run until turned off and then the same thing. any ideas.
Please help. at this point any ideas will be tried. Wear boxers instead of briefs what ever
I hope my wife doesn't find out how much is really going into the truck. Things that I have learned owning this truck.
Never name Animals you are going to eat or trucks. You never be able to eat the animal or sell the truck.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
