Tractor Talk Discussion Board |
OT 98 Chevy Blazer...wierd stuff
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Casey in Ky on November 13, 2004 at 14:36:29 from (69.176.39.4):
A couple of days ago the wife went out and tried to start her blazer. It would start then die. I managed to get it started buy pumping the gas a little and revving it some once it did start. I figured it was the fuel pump or if I was lucky the fuel filter. Well, I went out this morning and went to move the power seat and it just would barely move, just like the battery was dead. So I put the key in and nothin", just like it was dead. Then the seat started to move like it should and the gauges all came on(fuel pump too, heard it prime up), then it all died again, then back on, and off, and on. Most of the guages(including the speedometer were jumpin" around like they were on crack during all of this). Finally, it settled down and I got it started(it still died a couple of times, and I had to pump the fuel some, and rev it to keep it runnin"). Any ides?? Oh, I guess some more info would help. It"s got a 115,000 miles, LS that"s loaded(power everything), 4x4, and of course it"s the 4.3 V-6. Thanks, Casey
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|