|
Tractor Talk Discussion Board |
Starting to Pinch
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Allan in NE on July 29, 2004 at 04:16:17 from (148.63.132.164):
Hi All, The wife and I spent a considerable amount of time yesterday in the local NRD offices going over the water table histories in this part of the state (Western NE). We are toying with the idea of buying another tract of land and wanted to know what the ground water figures showed for the past few years in the differing areas. Things just are not good here. Due to the extreme dry conditions in our part of the country, ground water has been dropping at an alarming rate (5' in the past 10 years), which heretofore has been unheard of. According to the officials, we are only about one season away from the water from all irrigation wells being "rationed" out. 100 miles southwest of us, this is already being done & and the drilling of any new wells is banned. I used to have mixed feelings about the state boys having their fingers on the 'water throttle', but after seeing the maps showing all of the irrigation wells, I've changed my tune. There are so many 1,000 & 1500 gpm pipes stuck in the ground out here that this region looks like an oversized pincushion. So, controlling the pumping now seems to me to be a good thing. But yet, 300 miles to the east of us, the farmers cannot get the water to run off fast enough because they are totally saturated down there. Water tables keep dropping and the land prices keep rising. Must be a population thing. So, it looks as though we are going to be learning how to scratch the dirt in a dry land fashion. Please send rain, Allan
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
