Tractor Talk Discussion Board |
ENGINE REBUILD HELP!!
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Steve on July 17, 2004 at 18:25:02 from (209.26.189.100):
Guys yall help me out again. I posted a message a few days ago about my Case 300 new rebuild a few pages back. One of the head bolts was leaking water out of the top of it after cranking it up for the first time. I pulled the head off and I could not seem ot figure out what it was. The only thing was that the first two cylinders had really smutty, slimey, black oil on top of the pistons. I dont know if the leak is because of the head gasket not sealing or the head has a crack in it. Like I said a few pages ago I just had the head rebuilt and I dont know if the machinest magna-fluxed it or not. There are two water jacket holes approximately 1/4 of a inch away from this head bolt. I tried K&W block seal and also pulled the bolt out while the head was still on and put some permatex sealer on the end of the bolt and reinstalled it, and it still kept leaking? any sugggestions please!!
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|