Tractor Talk Discussion Board |
Super A engine
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill Caldwell on May 02, 2004 at 20:22:50 from (12.73.92.199):
Got a 57 Super A. Few years, truck patched 4 acres- Engine was weak when I bought the tractor- used oil, smoked, got weak- plugs fouled quick- no room in blacksmith shop. Tractor set outside for a year- got some water in a couple cylinders. Pulled head- sleeves are rusty. Question, Am I going in the right direction by buyin' sleeves, pisstons, rings, gaskets, getting a valve job, getting the engine running to farm this year? Had good oil pressure so I'm gonna try to keep the same bearings. When I pull pistons will mic crank to check for wear. I've got a small machine shop, lathes, mills so on. Notice the pistons have bushings, I've got a lot of reamers, some adjustable. . . what's the best way to fit the pistons to the connecting rods. Will be 63 this June. . . would like the tractor to last the rest of my years. Also what's the best way to pull the sleeves? Thanks in advance for any answers. Bill Caldwell
Follow Ups:
Home
| Forums
Today's Featured Article -
History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|