Tractor Talk Discussion Board |
FORD 801 WORKMASTER
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Eddie Petty on March 20, 2004 at 14:51:23 from (68.119.174.176):
Hello All.. I usually stay over on the Red and the Persian Orange boards but today I have a general question. I'm trying to help an older feller down the road while he recovers from knee replacement. His 801's lift has reportly been slowing down for years....well, it's at about stop now. I hauled it home today, checked the fluid and found a sump full of black molasses !! I attempted to drain the oil through the drain plug and nothing came out...that is until I poked a screwdriver through 3/4" of hardened sludge !!! Now the question(s): What is the recommended procedure for removing the accumulation of crud without promoting seal leakage ?? Does this model FORD have a strainer/filter and where is it located ?? Thanks in advance, Ed in 'ole Virginny
Follow Ups:
Home
| Forums
Today's Featured Article -
Restoration Story: 1951 Farmall H - by The Red (John Fritz). I have been a collector of Farmall tractors since 1990 when I first obtained part of the family farm in Eastern Indiana. My current collection includes a 1938 F20, 1945 H, 1946 H, and the recently purchased 1951 H. This article will focus on what I encountered and what I did to bring the 1951 NEAR DEATH Farmall H back to life.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|