Tractor Talk Discussion Board |
Re: Farmall 460 chassis vs. 504
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on March 11, 2004 at 17:36:03 from (64.228.12.178):
In Reply to: Farmall 460 chassis vs. 504 posted by Tom Dennis on March 11, 2004 at 12:10:47:
Tom: Joe has just about covered it all. The rear chassis will share a few components, but very few. Torque tube with the TA is probably the same or very close. Early 504 had the same IPTO. There may be a few common drive line parts. The chassis itself on 460 is the same as 300 and 350 and would be in the same weight class with 504. However the 540 chassis is designed with the operator moved foreward, built in 3 point or fast hitch complete with lower link draft sencing built right into chassis. You mount and dismount a 460 from behind the rear wheels, while 504 is from in front of rear wheel. Now if you are asking if the three major components; engine-to front, torque tube and rear end will interchange, I would almost bet they will. Putting operators platform, sheet metal and associated attachments on the beast may be a chalange though.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|