Tractor Talk Discussion Board |
F-M Magneto Dissasembly Questions.
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Chris(WA) on February 17, 2004 at 16:52:53 from (204.182.70.237):
Took the mag for my Allis-Chalmers WF apart to clean it up. The armature doesn't seem to want to come right out of the housing. Got the seal out but it has a seal holder staked in behind it. Tried a few wacks with a plastic hammer but no luck. Is there a snap ring behind the seal retainer or is the shaft just a tight press fit? Also was wondering about timing the gears. Label says there should be two letters on the large gear but mine has just a scratch mark on it. I imagine I set the scratch at the beveled tooth of the small gear but would like to hear from somone that has been down this road before. Any other tips would be appreciated! Thanks, Chris
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|