Tractor Talk Discussion Board |
Re: Setting the brakes on 1964 Ford 2000
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mark on January 27, 2004 at 08:38:28 from (199.46.199.230):
In Reply to: Setting the brakes on 1964 Ford 2000 posted by Bill on January 22, 2004 at 17:54:34:
There is a long (30") piece of rigid wire with a loop in the top at the rear of each side of the seat. The other end of the wire(s) connect to a gear which meshes with a gear attached to the rear of the break pedal arm. Correct application of the brakes is to depress the desired brake (firmly) and pull up on the wire which locks the brake teeth into the pedal teeth. Then release both and the brake pedal stays down in the depressed position. To realease merely tap the brake pedal which allows the brake teeth to fall away from the pedal teeth and the brake pedal arm returns to the relaxed (horizontal) position. The brake toothed gear must be able to float freely. If it is jammed up with rust or paint it won't work. Usually on these older tractors some or all parts are missing and complicates the process. Hope this helps, Mark
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|