Tractor Talk Discussion Board |
Re: Hydraulic press cylinder
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Wayne on December 11, 2003 at 19:32:35 from (64.12.96.236):
In Reply to: Hydraulic press cylinder posted by Roy Suomi on December 10, 2003 at 20:52:31:
Hey guys, I saw all the discussion about using twin rams. I know OTC routinely used twin rams in their line of cylinders, and if I'm not mistaking one of the applications they used to use them in was their pin press, until they quit making them that is. I believe they used either a 50 or 75 ton twin ram for power. I have a 30 ton Twin Ram on my truck now that has a single oil connection with the bases connected together and a crossbar on the rods with a hole in it. It's designed to do basically the same thing Enerpacs Hollo-Rams do to be able to push or pull depending on how you set it up..... As long as you both cylinders are connected together(IE one oil supply from the pump) they will always act with equal force, just like a set of lift cylinders on a loader do. Roy, good luck on your press. We made us a "portable" one several years ago with 75 ton single ram to break tracks with and it has been a lifesaver.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|