Tractor Talk Discussion Board |
Hey! RustyFarmall !!!
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Allan on November 27, 2003 at 12:09:26 from (148.63.132.164):
Rusty, "The timing could be slow".??? "The timing may be slow"????? WHADDA MEAN, "The timing could be slow"????????? I don't want to be disrespectful to you Sir, but I think that you are far too conservative with your use of the adjective "slow". :>) I had some time to work on the old sister this morning and the first thing I did was check the points. Surprisingly, they were very, very close to the .020 setting, so I just touched 'em up a little and then went after that timing. I think if the timing had been set any slower that the engine would have been spinning backwards! LOL I had to move that distributor quite some distance to get it to come in....but, Oh Boy! Does she ever pull now! Like a Farmall should! I'm one happy camper!!! As an added bonus, I've been quite disappointed with this new muffler that the previous owner had installed prior to my buying the tractor. It just always seemed far too loud. Sounded like one of those old flat-head Ford trucks of years gone by. But now, at idle she is quiet as a mouse and has that distinctive Farmall "ring" sound back in the exhaust. Now, I think I better get after building those gussets before I break this old gal in two. Thanks, & wish you were my neighbor, Allan
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|