Tractor Talk Discussion Board |
Re: Re: JD 317 Kohler KT 17 is it the Series II En
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob on September 21, 2003 at 20:19:56 from (66.163.134.177):
In Reply to: Re: JD 317 Kohler KT 17 is it the Series II Engine posted by steve II JD4000 on September 21, 2003 at 17:40:20:
More exactly, does it have the mounting area cast into the block for a filter? Many of the conversions were done with the oil filter not installed, and a cover with an internal oil passage installed where the filter was supposed to be because the engine shrouding for the 317 application interfered with the oil filter. All engines that are series II have the mounting area for the filter just behind the magnetic clutch on the front (PTO) end of the engine on the RH side. A series I engine WILL NOT HAVE an oil filter, OR A PLACE TO INSTALL ONE. If memory serves, Tony is correct that a series over 24300 would be a series II engine. I is more accurate, however, to look for the filter mounting area, as the series # is on the engine sheet metal, which sometimes does not correspond to the engine beneath the sheet metal!
Follow Ups:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|