Tractor Talk Discussion Board |
Re: Gaskets?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by wdTom on July 06, 2003 at 16:34:59 from (155.212.223.252):
In Reply to: Gaskets? posted by Sean W on July 06, 2003 at 00:09:28:
I mostly agree with what the others have said, but will add. I use a THIN film of one of the silicone gasket makers or sealers on a lot of gaskets. It seals but doisn't stick too bad when you hve to take them off. I too have heard of and sometimes use grease. One impoetant thing with sheetmetal amd some castings is to check them for a flat true gasket surface. Oil pans,and valve covers seem to get overtightened and sprung out of true. Some carefull work with a hammer and an anvil or some such can straighten them out most of the time. Then don't tighten them enough to spring them again.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|