Tractor Talk Discussion Board |
Re: Ford 640 Carburetors
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Howard Yoshida on June 20, 2003 at 12:15:44 from (24.161.152.103):
In Reply to: Ford 640 Carburetors posted by Chris on June 20, 2003 at 09:07:47:
Aloha, how does the engine run with the carb leaking? Where is it leaking from? Some carbs have a drain hole for excess gas so if it is leaking from there on a level surface it may be: If you are using the original float and it is brass, take it out and shake it to see if it has gas in it. If it is made out of that black plastic material it may be saturated with gas. If yes to any of the two, even though the float is adjusted correctly it will not completely close the needle valve. Check that the seat is ok, no nicks or foreign stuff on it and also check the needle valve. Hope this helps. Mahalo, Howard
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|