Tractor Talk Discussion Board |
Loose Sleeves
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jason on August 18, 2002 at 16:26:44 from (67.201.51.93):
I ordered a over haul kit for a Farmall 130 (c-123 engine) My question is about the sleeves. They seem way to easy to push down into the block. I did it with my hand all the way down. No tapping at all! It does hold water cause I have tested it,but what scares me is the very slight movement at the top of the sleeve when I jiggle it. I hear some people say its ok and that the head will hold them in place when bolted down. Others say it should be a tight fit. The reason I am rebuilding this engine is because of water getting into the oil. The old sleeves came out with very little effort. I thought because of bad o-rings. What do all you think? Thanks for any help!
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|