Tractor Talk Discussion Board |
Re: Re: Re: Re: Re: Static Timing using the ponts opening ... got a question !
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jon Hagen on July 24, 2002 at 11:29:41 from (63.160.198.40):
In Reply to: Re: Re: Re: Re: Static Timing using the ponts opening ... got a question ! posted by Bob /Ont. on July 22, 2002 at 21:26:37:
One question about the paper between the points method? Every mag I have worked with fires when the points close unlike a battery ign where the coil fires when the points open. Would you not have to slowly turn the engine untill the points close and grip the paper to find the firing point? My best luck has been to use a self powered test light connected to the mag kill terminal. The light will always be on because it grounds through the mag coil primary windings,but will get brighter when the points close because the points have less resistance than the primary winding.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|