Tractor Talk Discussion Board |
Re: Re: ring and pinion setup
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave on April 16, 2002 at 17:06:36 from (152.163.205.53):
In Reply to: Re: ring and pinion setup posted by Bob /Ont. on April 16, 2002 at 16:13:58:
Bob, thanks for the info. I may understand what needs to be done, but have never done it so I have no hands on knowledge of what a good contact pattern looks like. Also my first problem is how to set the pinion depth? My trans case is a solid rectangle with the only access point the very rear behind a cover. Looking in the case is like looking down a tunnel, with the pinion face facing towards me at the end of the tunnel. The shop manual shows a tool that slides into the carrier quills, giving a reference for the axle centerline and then shows putting a feeler guage in from the top as if the whole top of the trans case comes off to allow a view from above. No such luck, the top doesnt come off. Any idea on how to do this?
Follow Ups:
Home
| Forums
Today's Featured Article -
Restoration Story: 1951 Farmall H - by The Red (John Fritz). I have been a collector of Farmall tractors since 1990 when I first obtained part of the family farm in Eastern Indiana. My current collection includes a 1938 F20, 1945 H, 1946 H, and the recently purchased 1951 H. This article will focus on what I encountered and what I did to bring the 1951 NEAR DEATH Farmall H back to life.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|