Tractor Talk Discussion Board |
Re: ring and pinion setup
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob /Ont. on April 16, 2002 at 16:13:58 from (172.144.169.236):
In Reply to: ring and pinion setup posted by Dave on April 16, 2002 at 14:07:04:
Dave I'm shooting in the dark here, want you to understand. But always keep the old shims like you said. The best place to start. then get some PRUSSAN BLUE, in a tube like tooth paste. Coat a few teeth (3) in three places, roll the ring and pinion back and forth on each spot and look at the pattern. I would like to see the pattern (contact area) even on both sides of the tooth and nearer the center than the outside of the gear. You where right again by saying set the pinion deapth first, then the back lash. If you can't get an indicator on the teeth to check the back lash, mount a flat piece of steel on the pinion equal to the size of the pinion, in dia. and measure it there. You sound like you know what you are doing anyway, good luck. Bob
Follow Ups:
Home
| Forums
Today's Featured Article -
New Hitches For Your Old Tractor - by Chris Pratt. For this article, we are going to make the irrational and unlikely assumption that you purchased an older tractor that is in tip top shape and needs no immediate repairs other than an oil change and a good bath. To the newcomer planning to restore the machine, this means you have everything you need for the moment (something to sit in the shop and just look at for awhile while you read the books). To the newcomer that wants to get out and use the machine for field work, you may have already hit a major roadblock. That is the dreaded "proprietary hitch". With the exception of the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|