Posted by LSC123 on October 09, 2023 at 19:11:04 from (174.203.98.60):
I have a Farmall Super C from 1953 I believe and ran into a problem a few years ago when the tractor started erratically misfiring (sounds like its about to run out of gas) so it was parked for a few years when we recently bought a new zenith carb to solve the problem to no avail, still misfiring. It was also surging bad so I pulled the governor housing off and replaced a broken adjustment spring and the surging stopped but still misfired, cleaner the condenser points and put in new plugs but still surged, could it be ignition problems or compression problems? The tractor fires right up most of the time which leads me to believe its not compression, and a cant find any diagrams on adjustments for the zenith carb, I see the screw on top for the float height adjustment, but there is also a bolt right across from the fuel inlet fitting, is this for air or fuel of just to hold it together? Could there be an air leak somewhere I dont know about? Help would be much appreciated, thanks. Logan
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
