Posted by Ultradog MN on September 22, 2023 at 14:52:39 from (172.58.85.251):
I grouted the tile in this shower surround today. Did this kind of work for 30+ years before retiring 2 years ago. Normally I could lay up the tile for a typical tub/shower like this in maybe 10 hours - depending on the tile. I have 36 hours in this darned job. I didn't want to do it. Gave the woman the names of two other tile setters I know. They wouldn't touch it. Customer is my wife's best friend's daughter. It HAD to be This tile and it HAD to be set this way. I set some conditions. 4 hour work days and NO promises that I could hold 3/32'' grout lines through out. It took me 2 weeks. I thought about that old Chinese form of torture as I did this. There wasn't a 1000 cuts but there was most of 400 cuts - many of them twice. I will go back on Monday to caulk and install the faucet trim parts. Then I'm gonna go up to my land and fart around on my tractors for a few days. Clear some brush for deer hunting, etc.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
