Posted by IHCC51 on July 09, 2023 at 13:29:52 from (24.177.193.149):
I have my Grandfathers 1951 Farmall c, the engine in it when I got it was a c123 with a bad head, I replaced it with a c135 from a 404 so I could pull my mower. The c135 runs at 2,300 rpms the original c113 ran at 1,875 rpms so I wanted to run the c135 at about 2,100 to not get too far above the 540 rpm pto. If I adjust linkage and governor I can get 2,100 but it will not idle down. It has the C governor and a replacement carburetor. Best compromise I have been able to get is 1,000 low and 1,800 high, any ideas? Also the 404 radiator would not fit my C chassis and the C radiator would not fit the 404 engine, I was advised to get a 140 radiator, but now it runs hot. The radiator I bought was new but only has 2 layers of cores , is that normal for a 140 or did I just get a cheap one.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
