Hopefully you have or can access a 4 inch angle grinder. There is a lip on the front of the ear where the machined area on the front surface is. When I say ear I mean the part of the casting that sticks up that the bolt is stuck in. I would suggest you grind that square. This is for the purpose of pounding on the cast ear and the grinding will help avoid the cast edge from chipping away. The purpose of the pounding or maybe a better term for it is ..wrap.. to loosen the bond between the bolt and the cast. In a very minute way it will expand the hole the bolt is in. To explain more you are going to pound at it pretending the cast part around the bolt is a rubber hose. The blows are going to repeatedly, microscopically for just a microsecond egg shape the bolt hole around the bolt. Use a hammer about the size of a carpenters finish hammer which I believe is 16oz. Tap on it with a swing equal to that required to drive a dry wall nail in a 2x4 or a 4 penny box nail. Which has a shank a bit bigger than a pencil lead. This type of technique and practices are all based on blacksmithing. After the pounding you need to try the washer and nut again. Right after the welding tap on the casting again using a stubby punch with a least a 5/16 diameter contact surface with the cast. I do agree with wore out, before spending a lot of time on it I would blow it out with a cutting torch. It is funny how different folks use different terms to describe something. The word ..wrung.. does mean ..to twist.. His subject line would have been easier to understand if it would have said ..IH 1086 bolt wrung in two..
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
