There may be a filter before the oil returns to the tank, but it also goes through your valves before it goes to the tank. Score them and cylinders up with the things you want to try, and you will need replacements.
Copper spray is a sealing/adhesive coating for the interfaces of non-moving parts, that get clamped together, not a wear coating that gives a hard-wearing surface for moving parts.
Loctite 660 is an anaerobic retaining compound.
I have used Loctite 660 for retaining purposes as intended (and many other Loctite products for other things) and copper spray on gaskets. Don't you think if the products you are talking about worked for your purposes, Henkel/Loctite would have proven them and advertise them for such, then people would be telling you to use them?
My advice, not that you will care, is: Don't try to find something that might stick in pits. I've seen it tried on cylinders and rods, and it never lasted. Just hone the cylinders and polish the rods with crocus cloth and reseal them. Use a whetstone on any big pits on the rods to smooth the edges before the crocus cloth. If they are real bad find a shop capable of replacing cylinder barrels and making rods, if they are not standard off the shelf cylinders.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.