There is a high probability that the left track clutch is not releasing. If it turns right when the right lever is pulled, and goes straight when the levers are hands off, the right track clutch is working correctly. To turn, that dozer uses three components. The first is that it has no differential, it is solid, both tracks get equal power through the ring and pinion drive and finals. Between the ring and pinion is a large multi plate track clutch (one on each side, driving one track each). Around this clutch is (IIRC) a band brake that attaches to the lever and foot brake on that side. Pulling the left hand lever a few inches releases the multi disc clutch on the left track. this stops power from going to the left track. The right track is still under power, so the machine now drifts left if just traveling or turns left if pushing or pulling a load, but not sharp left. Pulling the lever back farther hard causes the band brake to grip the left clutch housing slowing it (or stopping it). if more braking is needed, the foot brake on that side just adds to the effort on the left turn lever, stopping the track. the clutch is not releasing on that left side. it is a major task to access the track clutches. they are heavy and require special tools to disassemble as they have a radical coil spring inside each one. I have owned a TD-18A with that problem, and fixed it. It was left in a creek on the left side and got water in the left clutch and final drive. Like yours it only turned one way. Parts can be found, or just cleaned up and reassembled if OK. I would guess the feel of the levers are about equal when pulling them back, indicating that the release bearings are both adjusted OK. Jim
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.