Posted by dhermesc on June 15, 2022 at 06:51:17 from (12.149.56.202):
We recently purchased a MF 1130 tractor. Looks rough as a cob but actually runs pretty good - until yesterday. Son ran it out of fuel on a steep incline - refilled the fuel tank and went to start it and nothing - not even a click from the solenoid. Messed around with it and finally got it to click but would not turn the engine over - then it wouldn't click anymore. He pulled the starter and took it to NAPA - they tested it on the bench and it spun over like a top - but took 200 cranking amps (?) to do so with no load.
Son and I took it back to the tractor and we thought - possibly it was on a dead spot on the armature when he first tried to start it and rolling around in the bed of the truck may have gotten it to a good spot when it was tested. Basically the hit it with a hammer cure. Put it back on the tractor and nothing. On a hunch I told him to run the jumper cable from the + on the battery to the solenoid. We then jumped the solenoid. The starter kicked in and tried but wouldn't turn the engine over. Tractor runs on a single 12 volt battery.
My assessment - the starter is about burned out with all the amperage it takes to roll it over and isn't strong enough to turn the engine over, and the battery cable needs to be replaced as it was probably damaged supplying that much power at every start up and the final start up fried it.
The engine is not locked up (my first fear) as we rolled it over by hand.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
