Posted by Jim.ME on March 12, 2022 at 12:41:35 from (67.242.176.154):
In Reply to: Allis WD valves posted by clayman on March 12, 2022 at 09:13:43:
There are a number of ways to set valves as you are seeing. Your post sounds like you might be trying to do it by the Rule of Nine's method, but your numbers don't add up. If, you haven't succeeded yet and haven't decided whose method to use, I suggest you go with Dieseltech's method for now.
Forget about the mag. Forget about feeling for compression. Always rotate the engine in the direction it rotates when running while making adjustments, to keep geartrain slack in the proper place. If you go past the point wanted you can back up, but back up more than need then turn forward in the proper direction to get to the point you need.
You have the rocker cover off, so look at the rockers. If #1 cylinder is at TDC on compression, both valves on #1 cylinder should be closed and the #4 valves "on the rock" (look closely at the rockers as you turn the engine and you will see the exhaust is finishing closing and the intake is just starting to open). The timing mark should be lined up, if you want to check it. Set both valves on #1 cylinder. Turn the engine 1/2 a rotation. Valves on number 3 cylinder should be "on the rock" and the valves on #2 cylinder will be closed. Set both valves on #2. Half a turn more and #1 will be "on the rock" so you can set #4's valves and half a turn after that #2 will be "on the rock" so you can set #3's valves.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.