Posted by Geo-TH,In on January 05, 2022 at 10:14:43 from (50.102.18.81):
In Reply to: who dropped the ball posted by jm. on January 05, 2022 at 09:27:07:
jm, One news story this morning showed jackknifed semis in the middle of the mess and no exits close by to get on or off I95 for help to arrive. One story said they got 3 to 4 inches of snow per hour. Another story said they couldn't pre-treat because the rain would wash it off.
I can tell you one time I was on I 70 and got caught in a blizzard. I 70 became pot hole city. Snow got packed in my cars and semi's and no way for snow plows to get the hard pack off the road. I took to an exit and hopped on US 40 that paralleled I70. The road had little traffic and was clear sailing back to Terre Haute. The road crew didn't have packed snow to deal with.
Around Terre Haute, snow crews are pretreating before it snows and plows are running when the snow begins. Too late to remove snow if you wait for the snow to stop.
So no pretreating because it was raining. Too much snow too fast is another reason. Too much traffic that packed the snow and couldn't remove it.
I'm lucky to have a county commissioner living on the same road.
1.25 miles to main road 63 and 63 is one of the roads that gets pretreated and plows are going by my house before it starts snowing.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.