As the others have said the shifter came out of place and it and did not move the last gear it was in back to neutral. Also as was said by SDE on the model you have the ..shift tower.. unbolts from the trans deck cover. In the 1st attached link it contains rough dimensions for the shifter tip. The dimensions are for an H & M but I am 80 percent certain that the shifter tip was the same on these later models as well. So the reason I am giving you this is if wear on the tip of your shifter seems evident you can weld up the end and grind it to the dimensions shown. Then you will be back in business and hopefully stay away from this issue during future use. If the dimensions in the link seems way off disregard them because there must have been a change between models. In that case I am sure if you study the tip well and see what looks to be worn away and replace that metal I am sure you can get it built back up properly without dimensions. Secondly make sure the shifter is not real loose up and down in the shift tower. In the attached diagram of the 2nd link spring 5 holds the shifter up against the swivel ball on the shifter. The spring pushes down against shield 7, so make sure that you can turn that shield slightly on the gear shift to show it is not rusted in place. On the farm I grew up on we had both a 350 and 300 as well as two Hs and an M ..I still have the M.. All suffered from the same problem. Generally if you are familiar with the motion you can maneuver the shifter to pop back in the proper position and go on. That takes a little experience though. Hope this helps!
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
