Posted by super 55 on May 27, 2021 at 21:54:11 from (96.55.21.207):
Hope this is a good place to get some info on using a box blade. I want to re-do my gravel driveway, and to level out some uneven yard. I will be using a 6 foot box blade, a 5 foot doesn't quite span the tire track on my Super 55. I have external hydraulics and was thinking a hydraulic top link would improve the ability to level with box blade. Any thoughts on this set up? I have to pick the box blade up this weekend, and figure it would be best to see what size to link I will need once the box blade is installed. Anyone have a similar set up and suggest the size of top link? I purchased this tractor several years ago and over those years I replaced or repaired anything that needed attention and also had the diesel engine rebuilt. And it got a paint job. The only implements I have used on it before the restoration were a rear mounted trip bucket and a back blade. Any suggestions will be appreciated.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.