Well I have a little puller, hopefully it will be enough. Looks like that blade bracket is part of a hub. Where on the bracket or hub should I apply the heat? Is this a procedure where I heat it, apply some wax in there if it will take any, and then douse it with water to break it loose? Or just heat it up and use some wax or WD and then work on with a hammer without cooling it?
Didn't think about putting the nut back on. Thanks.
Besides some broken welds where that guard attaches to the bracket, one of the blades doesn't turn easy so it must have something stuck to it or something could be bent.
Bot it on Purplewave and like everything else I've bot from them, they are selling them at auction for a reason and the reason is because everything is busted, rusted, bent, and broken. There is a lot of things pictures don't show. Got a 6' planning to get a bigger tractor but ended up buying that Ford 1500. Hooked it up this week after I got some long bolts/pins since it is a cat 2 and it ran ok as is with no loud noises and it didn't seem out of balance. The Ford 3 point would pick up the front end allright but not quite enough to get the rear wheel off the ground. Think it will mow ok that way. Going to try shortening the top link some more. The mower mount has a bracket on the top link that will rotate up and down which I learned reading here that it should help when mowing over rough ground.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
