Most likely all the hydraulics on it are aftermarket anyway, valves, cylinders, and hoses. Hydraulics shop I have gone to just gets out the calipers, measures the OD and the thickness, then pulls one off the shelf with no hunting around for part numbers. Orings will likely be standard sized that you can get anywhere. If you compare the valves you can tell who made it or their may be a number that identifies the maker. Cessna made a bunch of them back in the day. I worked for them one summer running a multiple spindle drill press constantly putting a valve body in a jig and then the press would drill 5 holes all at once. Had to make my quota of over a hundred an hour, checked one every so often to make sure fit on the standard, and changed bits when I thought they needed it.
If you have a bad valve, then order a new one from Surplus Center which are reasonably priced. DuAl made loaders also and same thing with the hydraulics. If you like the hoe then buy it. Go to the surplus center site and price the valves. Depending on the flow rate you can get 3 to 5 spool valves for 300 to 500.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
