Not a problem , Ya want a type 2 bell housing to mate the over under , ya need a flywheel and a starter . any truck junk yard probable has a type 2 Mabaughs (sp) will have the flywheel and starter . Engine mounts that one is on you . Several years back my buddy found a 2150 FWD with a pucked Herc. , the cost of doing a total out of frame with the needed machine work was going to make that rebuild cost over 6 K . Found a 8.3 from a gen set with under a 1000hr. and a reverse sump pan for 3250 , this one had the type 2 bell already on it . For us it was a two hour ride out and back to get the pieces and parts needed a trip up to Cummins for a special hose and tack drive . On the 2150 due to the ft. drive shaft we had to do mods to the oil pan and pick up tube . the 8.3 was set at 220 Hp at 1980 RPM . To get pto speed i set it to 2450. Of all the engine swaps i have done this was the easiest . If it was not for the drive shaft we would have had that puppy out the door in a day.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.