Posted by wore out on November 11, 2020 at 20:42:39 from (64.255.159.199):
In Reply to: New to the site posted by JW85 on November 11, 2020 at 19:00:07:
"did the usual new plugs,wires,battery,points,condenser"
I don't know what's "usual" about that except perhaps to you, and unless any of those parts were truly "bad" you went backwards by replacing them with today's parts, likely from "The Land of Almost Right".
How are you checking spark, there's "spark", and there's spark "hot" enough to actually make and engine fire and run.
If in fact you have a reasonably "hot" spark, (with the ignition switch "off") remove the sparkplugs and squirt a little gasoline in each cylinder, then replace the sparkplugs and install the wires and see if it will fire.
If it DOES, until the gasoline squirted in the cylinders is burnt up likely you have a carburetor issue.
Just because there's a good flow of gasoline TO the carburetor doesn't mean it's getting THROUGH the carburetor and to the cylinders.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.