I have an 81 year model 650 John Deere and had an IH Cub Lowboy loader that was adapted to it and used for about 12 years until I bought a TLB unit. It was very simple to do. I just made a couple of brackets to fasten the loader frame onto the tractor right at the clutch housing and then a couple more brackets to attach it to the weight carrier on the front of the frame where you put the suitcase type weights. I tapped into the tractor hydraulics on the front side of the lift unit where the hex shaped plugs are and you have to install a plug internally to get power there and the oil return was piped to the hex plug on the left side of the transmission about half way down the case. It was very mean to steer with a loaded bucket. One thing that helped was to replace the rib type front tires with automotive tires that had flat tread and I eventually installed turf type tires on the back because the ag bar type tires would dig a hole if they ever spun but the turf type tires did not do that as bad nor do these type tires mess up the grass when mowing and turning around.
I finally added the John Deere field install power steering kit on mine. The power steering hooks into the hydraulics of the tractor the same way. If you can find a schematic of the power steering oil flow and it will guide you. I just sold the power steering kit I removed from my 650 this past week. I had taken it off because with my 5' flail mower on the back of the tractor the front end was so light with the power steering you had no feel of where you were going so I removed it. The 650 is one tough little machine. Gene Davis Tennille, Ga.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.