Posted by glivengood62 on June 29, 2020 at 09:57:56 from (12.167.67.146):
I recently bought a Int 1086...serial number shows it to be a 1978. It has a digital dash center that has a switch that will move around to RPM, MPH, 540 PTO and 1000PTO. What I have read so far is there is an older version and a newer touch screen data center that was put on these tractors.
I am not getting any lights out of the data center....I replaced all of the fuses in the kick out panel and found the inline fuse and replaced it. All of the wires seem in good shape and traced from the harness that plugs in to the data center down to the fuse panel.
In looking at the harness....the are several numbers on both the harness and the back of data center. But not sure what number represents what.
Once I replaced the fuses...the gauges on the other side of the dash began to work.....Oil Pressure gauge....voltgage gauge....temp gauge...gas gauge is not working the needle just sits there and shakes on the E side of the gauge.
I have not pulled out the RPM transcender yet to see if it is dirty..but I am assuming..if wires are good..fuses are now good...tractor fire up and have power to my radio...ac fan unit..windshield wiper, horn....then would I then assume the data center is just bad? Is there a way to check it out or a better way to determine which part of the harness is to be hot or not?
Fairly new in getting back into farming....so my terminology may not be spot on..but any ideas or questions and I will respond.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
