3100 was ag..could be had with 4 sp, 6sp, or 8 sp or sos trans. Ag tractors had the adjustable width front ends
3200 would be a rowcrop except no row crops were made in the 3000 family.... you have to move up to 4000, 5000, and 7000 to see rowcrop models.ie 4200, 5200, and 7200 submodels.
3400 was the utility version that had a heavier front end that was a fixed ibeam type that carried more weight than the ag tractor... other than the front end, the rest of the tractor was based on options... as to tranny, 3 pt, and pto configuration. But the front end was set in stone. Was popular for front end loader tractors.
3500 was the industrial model with a 10k lb front end axle, that had king pins and a heavy nose cone over the radiator. This tractor was the one used for backhoe frontend loader tractors. BUT the front axle and nose were what made it the 3500. Tranny models (including a torque converter and shuttle reverser), pto, 3pt, back hoe, front end loader were all options on the 3500...
a 3400 will share most parts with a 3000 of the same transmission configuration. but the front end and steering parts were a bit different as mentioned.
bouncing tach ... can be cable bad/dry, or the tach end needs lube, or there is/are dry parts in the actual mechanism. the nylon gear in the tach drive on the end of the generator can also be missing teeth or slipping at the cable slot. All these parts are available and reasonable.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
