I understand your reasoning all is good. Even though I didn’t comment on it I have some earth moving genes. My dad liked all sort of projects like that and in part that was passed on to me. He had an eye for grade when fixing terraces on our KS farm. He also ran the road grader in our township. Early on my grandpa also helped with the local roads but I think it was more out of necessity back then. I think part of what he did involved a team of horses. On a little more of an antidotical note when we had the local bulldozer guy come out to our farm in the 60s and 70s to put in terraces, a pond or clean up trees my dad would always be out there with our trusty Farmall H with the trip loader. We had a sprayer that mounted on the back that used two 55 gallon drums to hold the spray mix. He would fill them about half full.with water. He would clean up and pile brush, smaller stumps and pretty up the dribbles as he called it. The dozer guy would always comment how much that little Farmall could do. In the later years when the engine was starting to wear out we really kind of neglected it because we didn’t feel it was worth putting much money in. Its final demise was a ball bearing under a bull gear that popped out the casting. I now have that same ...Horndraulic... loader on my M. As far as the depth you should cut it out to I can’t speak for that. I could not make much out of the picture you showed of the wash out you said you were fixing.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
