I just saw a loader on an H on FaceBook yesterday that sounds like that Sears loader. Ii had never seen even a picture before yesterday. Caswell loaders were pretty common around home in the late 1950's and early '60's till they all got replaced. Had a LARGE cylinder mounted low in front, pointed straight up right in front of the grill of the tractor. Two chains crossed over pulleys on the top of the rod of the cylinder. Had pretty good lifting power even with the stock belly pumps on H's & M's. But the bucket bounced terribly across rough ground, no down force, was a lever on the right side mount on the axle carrier you could easily adjust the pitch of the bucket to get it to dig. Seems like there was an additional oil reservoir on the loader so you could lift the bucket higher than the 6 quarts of oil in the Liftall would allow. I did say that cylinder was really BIG. That Caswell survived a lot of years of use, survived better than the Stan-Hoist that replaced it. Saw a real nice Super M with a equally nice Stan-Hoist loader about 2 years ago right now. Really didn't have a way to haul it, was going to buy it for the loader and flip the tractor. It was gone by the time I decided to just buy it.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.