Posted by tom upton on December 30, 2019 at 17:12:59 from (104.249.226.168):
In Reply to: Cylinder Kit Help posted by connor9988 on December 30, 2019 at 11:21:50:
Seals will be available at any decent hydraulic shop, but you will need to take apart, identify and measure each one, so might be best to just take nut off piston, pull piston off and rod gland as there will be seals, wiper, and if your lucky a plain bearing of some sort inside it that most likely needs replaced or your new piston seal may leak from too much side to side movement, then just take to your local hydraulic shop and have them measure up and supply new for u to put back together?? Anyway I am sure you will figure that out. I just wanted to point out a couple things:#1 By what I can see in pictures the style of cylinder you have could be used for single acting or double acting, It probably has a vent/filter of some kind on cap/top end port. #2 the big problem with this cylinder being used for single acting is every time rod retracts it sucks in moisture, and some degree of contaminant, eventually rusting/pitting rod and more critical the cylinder bore which makes it difficult to get a good seal between piston cup and bore. Not wanting to discourage you, and maybe yours is fine, but before you bother with new seals take a good look inside bore. A better ( in some ways) single acting cylinder has no piston seal per say. It just has a large rod inside a relatively small cylinder and force is based on the area of the rod. This means cylinder has no vent and always has oil in it even when retracted. You can usually find one of these cylinders at tractor wrecker easily id'd by one port into cylinder. Just make sure rod is in good shape, and worst case scenario you need a seal kit for rod gland. ( or go buy a new cylinder at harbour freight or princess auto?)
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
