Posted by Jon f mn on November 10, 2019 at 16:02:31 from (174.219.6.191):
Made some more Progress on the fence this weekend. Had some help from 3 of my grandsons, Devon, my oldest grandson who is 17, Jordan is also 17 and Gage who is 12. Had to start with breakfast, they sure put the hurt on the all you can eat breakfast at the local cafe. Lol
We got the rest of the old fence out and the rest of the posts in for the new fence. The DC worked good for pulling the posts out and pushing the steel posts back in straight and in line.
Took about all she had to push those posts in in my clay tho. Lol
All the parts you can see from the yard will be 4-2x6 wood fence and gates. The rest is 4 Barb wire. It isn't any grampa love fence, but it is not too bad considering a lot of it is reused posts.
All the posts are all in and the wire is done on 4 runs, three runs to string wire yet, but that will have to wait for a while.
Next weekend I'll likely start working on corn harvest if the weather is good. Been putting that off hoping the corn dries down some. Tried to do a little plowing today, but the ground was froze too hard. If it warms up next week I may get some more done.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
